Jotul F 3 User Manual download pdf (Page 4)

INSTALLATION

IF THIS SOLID FUEL ROOM HEATER IS NOT PROPERLY

INSTALLED A HOUSE FIRE MAY RESULT. FOR YOUR

SAFETY, FOLLOW THE INSTALLATION DIRECTIONS.

CONTACT THE LOCAL BUILDING OR FIRE OFFICIALS

ABOUT RESTRICTIONS AND INSTALLATION

INSPECTION REQUIREMENTS IN YOUR AREA.

Reminder:

Your local officials have final authority in

determining if a proposed installation is acceptable.

Any requirement, that is requested by the local

authority having jurisdiction, that is not specifically

addressed in THIS manual, defaults to NFPA 211,

and local codes in the U.S. or in Canada, CAN/

CSA-B365-M and local codes.

INSTALLING THE VENTING

The F 3 CB can be vented from the top, the rear or

from either the right or left side. Follow the

instructions below for the desired venting location.

TOP EXIT VENTING

When top exit venting is desired, use a 3mm allen

wrench to remove the two set screws that secure

the top casting to the sides of the stove and lift off

the top casting. Lay the top casting on a flat surface

upside down and remove the 10mm bolt from the

traverse bar and remove the smoke outlet cover.

Reinstall the top casting, be sure to secure with the

two set screws that were removed. See figure 1.

TRAVERSE BAR SECURING

SMOKE OUTLET COVER

TO TOP CASTING

STOVE PIPE STOP

UPSIDE DOWN

TOP CASTING

STOVE PIPE STOP

FIGURE 1

REAR EXIT VENTING

When rear exit venting is desired it will be necessary

to knock-out the vent hole from the rear casting.

Remove the top casting of the stove by removing the

two 3mm set screws that secures the top to the sides.

The set screws are located on the outside of the stove

on the top of each side panel.

Using a 10mm wrench remove the double rear

heatshields from the back of the stove. Remove the

front door to avoid damage to the glass.

Reminder:

loss of the door washer will result in improper door

alignment when reinstalling the door.

Using a claw hammer or a small sledge hammer

strike the CENTER of the 6 knock-out disc from

the OUTSIDE of the stove. The knock-out disc

will break into four wedges and may need to be tapped

out. Touch up any remaining sharp edges with a file

or hand grinder.

NOTE: The IVORY F 3 CBs ARE REAR

VENTED FROM THE FACTORY. IT IS NOT

NECESSARY TO KNOCK-OUT THE REAR

CASTING OF THE STOVE. HOWEVER, IF TOP

EXIT IS DESIRED IT IS NECESSARY TO

INSTALL A SMOKE OUTLET COVER ON THE

REAR OUTLET OF THE STOVE.

SP ACERS

HEATSHIELD WITH

LISTING

LABEL

SHOULD

INSTALLED

ON THE

OUTSIDE

FIGURE 2

Reinstall the top casting and front door, remembering

the washer. The two rear heatshields MUST be

reinstalled on the stove. Remove the metal cover

plates from the heatshields and reinstall. Reminder:

there is a small nut used as a spacer between the two

heatshields. See figure 2.

1 2 3 4 5 6 7 8 9 ... 20 21

Comments to this Manuals

No comments

Jotul F 3 User Manual Page 4

Comments to this Manuals

Related products and manuals for Stoves Jotul F 3