Jotul GZ 550 DV II User Manual download pdf (Page 21)

Logset Assembly

Unpack and arrange the five logs as outlined below.

CAUTION: The logs are fragile. Handle with care.

1. Seat Right Log (1) on the pin on the right side of

the Burner Skirt. fig. 41.

2. Set Rear Log (2) on the pins at the rear of the

Burner Skirt. This log should overlap the back of

the Right Log.

3. Set the Left Log (3) on the pins at the left side of

the Burner Skirt.

4. Set the end of Front Log (4) into the pocket at

the rear of Left Log (3). Engage the other end

with the pin in the middle of the Burner Plate.

Fig. 42.

5. Engage the upper end of the Cross-over Log (5)

with the pin in the Rear Log. Fig. 42. Set the

Cross-over Log across the top of the lower end of

the Front Log (4) as illustrated.

6. Spread a layer of ember stones evenly over the

surface of the Burner Plate. Allow for 1/4”

clearance between the stones and the inner

edge of the Burner Skirt. Avoid blocking the pilot

flame area with ember stones. See Fig. 43.

7. Replace the Glass Panel Frame: Engage the top

of the frame with the three tabs at the top of

the firebox. Push the bottom of the frame

against the firebox face and pull the Frame

Latches out to engage them with the slots in the

bottom of the frame.

Figure 41. Install Right Log, Rear Log and Left Log in

that order.

Figure 42. Install Front and Cross-over logs as shown.

Figure 43. Install ember stones, keeping clearance

around the pilot crossover area.

Pilot

Area

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

No comments

Jotul GZ 550 DV II User Manual Page 21